Posted by RodInNS on December 05, 2012 at 15:12:51 from (216.118.158.123):
In Reply to: Why Triangular Tracks? posted by in-too-deep on December 05, 2012 at 10:41:19:
The primary reason for Cat High drives was to get the sprocket up out of the danger zone where it could be impacted by rock, etc on the end of the track frame. A busted idler is cheaper to fix than a busted final drive... Secondary concerns... high drive allows for an easier component layout in the transmission case. Those machines have a modular, planetary transmission that is easily serviced by pulling the sun shafts from the final drives and unhooking the input shaft... then undo the bolt ring on the back and the whole works slides out on a tray. So the machine is far, far easier to do major service on. IIRC, a Cat tech told me years ago that they'd have a 4H transmission on the truck in about 2 hours. You won't even hope to do that on any competitors machine... Beyond that... probably not too many advantages. I find the machine to be nose heavy with a high center of gravity. However... it does also have considerably more ground clearance. That can be an advantage.... Personally I like high drive dozers. You're also seated up high and have good visibility.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
