My dad had an old belsaw mill. Got tired of running it off our old case. When saw slowed, the 4 ft blade would change shape and not cut straight. He wired in 2 large 3 phase motors to fix his problem.
Try ebay for digital tacks. I purchased one for my mower on ebay. Yes made in China. It lasted 4 hours before it screwed up. After writing many emails to seller, I contacted Pay-pal. They got me a full refund. So, if you find a seller, try getting one based in the US and use pay-pal.
I have an old mechanical tach that you connect to the shaft and it tells me the RPM's.
My IH C and most old tractors have a 540 RPM pto. My tach confirms the 540 RPM's. Jubilee will spin a tick faster.
So, if you want 600 RPM on the mill, do the math, the pulley on the mill will need to be a smaller diameter.
My dad found the flat belt will slip a little when under heavy load and the tractor speed will be less too.
If I recall, dad put a pulley that would use 4 v-belts and 2 went to each motor. After that conversion, it saved him fuel and gave him a good cut. His mill was set up next the the big saw dust pile, next to his shop where he got the electricity from. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
