Posted by Andy C on November 04, 2012 at 05:46:59 from (74.103.170.179):
In Reply to: O/T Chain Link Fence ?s posted by fergienewbee on November 03, 2012 at 13:23:00:
Use the tension bands both sides. Attach fabric to one side, roll out the fabric and stretch it hand tight. Then remove the proper vertical wire by straightening out the top loop on the wire you are going to remove. Follow that wire down to where it is twisted to a bottom wire and untwist it. Now, with the fabric loose unscrew the wire. you should now have a piece of fabric that is slightly shorter than you need. In a 12 foot section you should be able to stretch by hand to get the tension bands on. Don't forget the piece of metal that fits vertically in each end of the fabric that the bolts for the tension band go against. If the fabric is overtightened it will just get shorter (the diamonds will elongate) There is a simple tool to tension the fabric but for short pieces another set of hands to slip the bolts in while you tension the wire should do the trick. Good luck, Andy All Fenced In
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
