Posted by Christos on October 30, 2012 at 18:37:43 from (64.134.165.154):
I have a question for you all - this past spring I got the Massey (135, Continental Gas, 6-Spd) to at one point stop misfiring (popping sound out the air cleaner). I did this by rotating the distributor until I couldn"t hear the pops anymore.
I decided to take the Tractor for a road trip last week. I ran the tractor in 1L-2L-3L. The faster I went the more popping I heard. I also have never been successfully able to get the tractor to run in anything higher than 1H.
It acts like starving for air, lurches forward and cuts off. I"ve tried to shift at a lower RPM but it still likes to cut out. I should point out that at times running in 1H is chore too.
Any ideas? I want to take my rotary cutter to the welding shop and it"s 3-4 miles from the farm. I"d prefer it not take an hour.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
