Posted by tjdub on September 10, 2012 at 22:22:31 from (208.74.246.137):
In Reply to: 4020 Injector Pumps posted by fatbob50 on September 10, 2012 at 21:42:59:
Honestly, I don't know much about injector pumps, but when I had the one for my 4010 rebuilt a year or two ago, they sent along soft copper washers for the lines. Even torqued to spec, two of them still leaked and I just "nudged" them with a 9/16" wrench and they stopped leaking and have been fine since.
With steel washers, I think you would be MORE likely to strip the bolts by over-tightening them. With soft copper or brass, the washer mushrooms, but with steel it seems like you're just going to rip the threads out of the pump. Maybe the washers they gave you are some other soft alloy, but just not copper colored?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
