There isn't wire or rebar in a cement block. This is only supporting a few pounds. JR suggested oil, did that. JM suggested wax paper, may try. Learned that the screw heads holding the forms to the plywood should be covered with grease to keep the concrete and sand out. Learned the plastic sleeves are not perfect cylinders. Did a little damage the last inch. I have a few ideas to make the cylinder extraction work better. Going to get more plywood. Allow the posts to set for a few days while I make more using the two forms I made. If there is a problem with strength, I'll make the mix a little stronger.
BOSS IS HAPPY WITH THE DESIGN AND THE LITTLE FLAWS AREN'T AN ISSUE.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
