Posted by John T on August 19, 2012 at 05:36:32 from (216.249.82.117):
In Reply to: Old handstart JD tractor posted by Loving John Deere on August 18, 2012 at 22:18:44:
Sounds like you may have to start with a new manifold, then the other things you noticed, carb fuel system liklely the Magneto etc. Id say its gonna be a while before you hear her pop pop pop pop.
The manifold studs will likely all break off meaning getting them extracted from the head and then having the head surfaces machined/planed down smooth and with a new gasket n studs and a manifold and some dollars step one will be complete. If youre not experienced there are several carb and mag rebuilders out there.
Once all that is done the mag needs timed so she snaps/impulses when the flywheels Left Hand Impulse timing mark is at the flat mark on the tractors side at 3 o clock. You open the petcocks for starting then close them once she starts
If youre not experienced this would take 100 pages of guidance so take it one step at a time and post on the JD page is my advice. Its gonna be a real money pit for a while
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
