Havent use it for several years but have a 12' x 12' crib that I think was about 600 bu. and it is on a wood floor, also a 10' x 10' and again on a wood floor. Both of them I made for use with a drag. They are just set on block pillars and the frame is an octogon (8 sides) and made of homegrown 2 x 8" timber with a 1" board floor. Had a coupel of others on concrete but the wood floor kept the corn in better shape, fact is even tho the concrete floor was higher inside than outside (crib set in the concrete) 2" of water would always be in the bottom of the crib. And the wood will probably last you as long as you are going to be able to have a corn picker. No need to put in something that you will have trouble getting rid of in a few years. I would definatly make it out of wood and with a drag spot even if you do not now have one becase in a couple of years you might find out you want one if your back starts hurting from the shoveling.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
