Posted by LorenMN on August 10, 2012 at 08:41:06 from (64.65.174.118):
I'm going to be putting up an 18' diameter 1000 bu. wire corn crib, and I'm looking for any suggestions for the floor. I'm going to dig out the top soil and tamp in class 5 gravel. Thinking that a concrete floor would be 4" thick, and I'd dig down along the perimeter for 12" deep x 6" wide footing, to keep rats from digging under it. I don't have a drag so I don't need a trench in the floor. I will be putting down the U-shaped ventilators on the floor before filling the bin. I have 4 acres that I will be picking as ear corn, and grinding for steer feed. Hoping I will get a 2 year supply so I can alternate to oats next year.
Is pouring this floor something that I would want to try doing myself? Largest floor that I've done before was 6'x9', haven't done anything that I couldn't put a 2x4 across to get level. Would I want to use fiber filled concrete? Any guesses on cost?
Or....Would I be better off to use green-treated 6x6's with 2x8's screwed to them, and set the crib on that and forget about concrete? Seems like that would be easier and cheaper for me to get done, since I only have about 2 months left to have the crib ready to fill. The space between the 6x6's would leave room for the cats to get under there to control the rodents. If I make the base square, I could dig a post hole under each corner and cement in an anchor for each corner. This option would be a less permenent too, so I could move it if I ever need to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
