There will be opinions and preferences by many I am sure.
Its nice to have adequate light when placing concrete, for the finisher at least, building that size, access for the chute, or for some reason you have a pump, probably not necessary, but its wise to consider how the material will be placed. So roof on or enclosed or not, kind of optional, enough work lights can be set up to illuminate or permanent lights installed before hand. Definitely need light one way or the other.
I'm not familiar with the slab edge and column detail is with pole buildings, maybe there is expansion joint or isolation joint around same for preventing cracking, but would assume the columns and the roof framing, and tin would be up, that would prevent weather effecting the finish, like a sudden rain or what have you. Access through the sides, whatever nailer or blocking for the tin is needed, bracing might be in the way, you could plan areas for the chute to place if the doorways do not provide enough access already.
If placed early, you'll want to wait the 28 days for curing and compressive strength, but afterwards, for remaining work, nice clean surface to work off of, just not something I would do if that is the finished floor surface and theres a bunch of trades that will work off it to complete the building, pole building likely not the case.
Don't forget reinforcing, extra where needed, all the stub ups, conduit, pipe, pex for heated floor and or anything extra like spare conduit, pipe for future use etc. Euclid Chemical Company makes great finishing products for your slab.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
