Posted by NCWayne on August 01, 2012 at 14:53:38 from (69.40.232.132):
In Reply to: Marvel Carb posted by Don E. Foster on August 01, 2012 at 12:54:59:
Like Old said if it has a needle with the rubber tip thye will often need to be tapped lightly to seat them before they will seal. I had a carb once that I couldn't get to seal for anything. I got spart one night and decided to seat it like you'd lap a valve in. So, I wrapped a piece of thread around the needle and spun it in the seat with lite fingure pressure on it. That was more than 5 years ago and it hasn't leaked a drop since.
If the needle doesn't have a rubber tip I've seen those that also needed the same treatment to get them to seat. The biggest difference is that when tapping them it takes just a bit more of a tap than the rubber ones do. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
