Posted by Kirk Grau on July 29, 2012 at 09:19:42 from (98.235.64.137):
Stopped at Lowes after church and picked up a cut-off tool. First thing I realized was that my little pancake compressor did not have enough volume to run this very long. Don"t have any other pneumatic tools other than some nailers so have not had that as an issue before.
Alternated running the cutter and whacking the slits with a BFH and cold chisel. Probably did not take more than 15-20 minutes to get the old one off. Put the new sprocket on with a shoulder bolt (grade 8), anybody have any issues with that approach. The "rivet" or pin that was called out in the parts book is no longer available from NI. Any real reason to shop around for a roll pin as some of you think should have been used in this application?
Filled the spreader up and took it for a spin. Seems to be working fine. Now probably have another 2 loads to take care of this afternoon.
Attached a few pictures. Thanks for the help on this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
