Posted by Texasmark1 on June 06, 2012 at 02:02:39 from (67.142.175.20):
In Reply to: Electronics help posted by Bill in IL on June 05, 2012 at 19:37:39:
105k could be 105,000 ohms of resistance, or 105,000 picofarads of capacitance. the +35 is unknown as either would have the tolerance marked like 1%, or 5, 10. or 20. 35% would be something that an electrolytic capacitor would state, like the very large start/run capacitors in an air conditioning unit. The shaped end is not normal for either. Could indicate the cathode end of a diode. A resistor or diode could burn like is shown in the picture. The resistor usually burns in the center as does the diode.
If it's a carbon resistor you can easily bend it and break it apart right where it burned. If a diode it will be glass fused to glass and won't break, it will bend.
Knowing what the rest of the circuit looks like could help in understanding what role it plays hence what it is. A circuit diagram would help even if you pencil it out by looking at and identifying the other parts and show how they are wired to each other.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
