Posted by HGB on May 26, 2012 at 14:52:47 from (209.33.5.96):
Need help covverting 1950 super A from 6 volt to 12 volt. I put a GM altornator on and wired it according to the step by step conversion for "M or super M" not sure this will even work for the super A. Now the tractor will not start. The one thing I am not sure about is the wire coming from the ballast resistor to ignition coil / distribitor. The tractor has the push / pull kill switch which had one side grounded to the tractor before I changed to 12 volt. Before I switched it over the switch had to be pulled out to kill the tractor now from what i can tell the switch has to be out to let power pass through. "out position switch is made , pushed in, switch is open" I have tried both ways and tractor does not start.I think i am missing something with wire going to ignition coil / distribitor. Any help would be greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
