Posted by mkirsch on May 25, 2012 at 11:37:19 from (64.80.110.74):
In Reply to: NebraskaCowman posted by DeltaRed on May 25, 2012 at 07:21:56:
If you don't mind my comments, the main problem with the side-entry idea is the location of the controls and seat on your Super M.
Park a 1256 and a Super M side-by-side and you'll notice that to get the side entry on the newer tractor, the steering wheel, pedals, and seat are all pushed way forward.
When you drop an ICB cab on a Super M, the only way to have the cab over the operator is to mount it far back on the chassis. Otherwise, your butt will be hanging out the back window!
Mounted back far enough so that you can be inside the cab, the rear wheels block the doors, and you cannot get out either side.
To get a practical side entry, you would relocate the operator's controls so that the rear of the seat is directly over the axle. It's not impossible, as someone has put an 86 series cab on a 560 before.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
