Posted by Inno on May 11, 2012 at 09:26:41 from (206.47.249.247):
I'll try to keep this as short as possible. I blew the front mounted hyd. pump on my 202 MF. It is a Cessna K 20644 ICEH and from what I understand you can not rebuild them once they are worn out....and this one is worn out! Has anyone had any luck finding a suitable replacement? I can find pumps that have the same or close enough specs to work but the shafts are always different. Mine has a 3/4" keyed shaft which is 1 1/4" long. Are there adaptors available. One thought I had was to get one with a 5/8" keyed shaft (I've seen a few that would work) and shim it with some 1/16" shim stock. Or would I be better off trying to find/make an adaptor or trying to find/make a new drive shaft for it?
Any thoughts appreciated. I've spent too much on this old tractor to stop now!! :?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
