Posted by Goose on May 10, 2012 at 19:20:39 from (166.250.224.239):
On my H Farmall, that is. Not in the state capitol.
Engine seems to be stuck on about one third throttle, no matter where the throttle lever actually is.
Took the top and side covers off the governor, and with the throttle lever disconnected, the governor worked free and easy across the entire range. Started the engine, and by working the lever on the governor by hand with the throttle lever disconnected, engine would speed up, and idle all the way down, like it should.
Put the covers back on and hooked up the throttle lever and it was back like it was, stuck on about one third throttle.
Something strange going on. If it works like it should by hand with the throttle lever disconnected, why won't it do the same with the thottle hooked up? What's the difference between my fingers moving the lever on the governor or the throttle lever moving it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
