Posted by showcrop on May 01, 2012 at 17:40:46 from (75.67.231.80):
In Reply to: Bad grease fittings. posted by Tom in Mo. on May 01, 2012 at 03:39:51:
Quoting Removed, click Modern View to see
I don't know if this is your situation, but grease fittings used to in some cases be driven into a hole kind of like a huck rivet. In which case you can drill and tap the hole for a standard fitting, but you should also remove and clean the hub so that you don't get steel in the bearings, I wouldn't worry about that on an old tractor wheel bearing because the bearings won't be working that hard and replacements are cheap. It looks like it is possible that it is a smaller hex on it like one that I removed from a wagon with vise grips Sunday.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
