Posted by The tractor vet on April 18, 2012 at 07:14:08 from (75.19.127.43):
In Reply to: Skid steer post auger posted by Jacksonduper on April 18, 2012 at 03:55:06:
Ya get what you can afford . We found ours on Craigs list and it was a like new John Deere as who made it for Deere i have no idea and we run it on a New Holland LX665 and it works for us . since then we have added a 4 1/2 inch Bell Tech rock bit and to get that i had to become a non stocking dealer for Bell tech , sorta cut out the middle man so to speak . as there was npobody close that stocked or could ge the bit we wanted and why should i buy the bit from Washingtons state and have it shipped from there to Ohio when i could get it shipped from the factory here for 450 bucks less. They have some fine drive units in the N C series would be a good choice for you. direct drives there is three models to chose from to match you GMP flow and pressure and they come with a two year warranty .. No i am not trying to sell ya one i am just saying that there units empress me . plus this unit has the 2 inch HEX drive that i like better. IF you were a neighbor i would order it for you but i am not going to say hey order it from me and start selling them. Not gong there . just like with the other stuff that i am a dealer for .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
