Posted by John T on April 07, 2012 at 15:50:59 from (216.249.82.117):
In Reply to: Ohms??? posted by Greg1959 on April 07, 2012 at 13:57:20:
I agree with those below, heres my answers:
"If I use the 10 or 12 gauge wire, will it affect the resistance to give me errors in tank level?"
NO The resistance of the short piece of wire, be it 10 or even 18, as compared to the sending unit resistance (maybe 30 to over 100 ohms???) is almost negligible so either will work and I doubt you could ever see any difference in the level indication regardless
Or should I buy a spool of 18 gauge wire?
If I were buying a spool of wired for general purpose hook up, Id go ahead and buy 16 or 14. Id buy stranded of course for better vibration withstand.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
