Posted by Hal/Eastern WA on March 31, 2012 at 13:48:52 from (67.5.111.7):
In Reply to: late night visitor posted by mjsnodgrass on March 31, 2012 at 12:13:03:
If it is that far off the road, I would cable and lock the driveway, with a metal sign hanging from the cable that reads NO TRESPASSING. If your ground is anything like mine is right now, if they drive off the established gravel driveway, they might very well get stuck in the mud. This time of year is also a great time to pound in metal T posts, as they go in really easily unless you have rock. Some barb wire on the posts will usually discourage all but the most determined thieves, and those will get in no matter what you do.
Are you living there? If so, you could get an inexpensive security camera and hook it up to a VCR. If there are some lights on, the camera might at least give you a chance to get the license number and description of the suspect vehicle.
If my memory of Washington state law is correct, signs need to say NO TRESPASSING. Signs that say something like POSTED or keep out might not allow a prosecution for trespassing.
Although the driving around without headlights on is very suspicious, it is hard to say just who is coming on your property. It could be lovers looking for a place to park or it even could be law enforcement officers prowl checking.
In my semi-rural area, lots of people have put up gates that block their driveways. Some have electric openers but most are manually operated. Some are really elaborate and probably cost a lot of money, but some others probably only cost a couple of hundred dollars to set up. Dealing with a gate or cable all the time is a hassle, but it appears that it might be necessary or at least a good idea.
Unless a burglar or thief knows what he is looking for is at a particular location, he will probably pass a place that is difficult to get to or which looks like it might be a place where he would get caught, and instead will go to some place that is easier and safer. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
