So far, what you have is a list of opinions. I could give you mine, but just as is the case with the others, it may or may not have any validity.
You need to look at your local/state building codes for requirements on engineered truss construction. You can build a building that is a virtual bomb shelter, and if it doesn't comply with building codes of jurisdiction. all is for naught.
I spent 40+ years in the construction industry, about half in the field (as a carpenter) then after completing a degree in structural engineering, I moved into the office as an estimator, then on to project engineer. I know how to design a truss, have the credentials to "certify" a truss, and have done so in compliance with building codes of our locale. That said, I wouldn't think of telling you what you can or cannot do in Wisconsin.
If the building requires a permit to build, or will be insured once complete, I'd make absolutely certain I was in compliance with local/state building codes.
True "engineered truss'" will have a stamp on each one, come with drawings as far as assembly/construction of roof system, and often go so far as to even tell you where/how/what type of fasteners you need to attach them to the building itself. Simply copying an engineered truss (from drawing) does NOT make it a certified engineered truss. It HAS to have engineers stamp on the truss itself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.