Posted by LJD on February 23, 2012 at 04:56:37 from (75.213.223.162):
In Reply to: Chain saw bar oil? posted by JayinNY on February 22, 2012 at 16:51:47:
I've been cutting wood for almost 50 years. 20-40 full cords of hardwood every spring-summer-fall. I have never paid a penny for bar oil. I've used nothing but used motor oil. I have never had any premature wear problems - not even on my 32" hardnose bars.
I heard tons of negative nonsense about motor oil being no-good. Kind of funny considering all the new bars customers bought from us over the years - and they used only the "best" bar oil. Many of those bars I took home and they worked fine. A mis-sharpened chain often wound up with a bar getting the blame. I still have a stack of 30-40 bars from the first Stihl/Homelite/Deere dealership I worked at in the late 1960s.
I must admit that I feel a little guilty pouring used black diesel motor oil into a new shiny saw - but that guilt wears off pretty fast.
I DID have a bar-oil problem recently. That in John Deere (EFCO) pro 56 cc saws with 20" bars. It wasn't the oil though. The oil holes in the bars are drilled too small and plug very easy.
I will never use any bio oil simply because it goes bad and rots when it sits too long. I've got several remote properties -some 1000 miles from home. They all have many chainsaws and I'm not going to be draining all my saws when stored. I learned that lesson a long time ago when I greased my dad's fishing reel with peanut butter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
