Posted by GVSII on February 20, 2012 at 18:44:16 from (67.249.163.187):
In Reply to: pull starting a tractor posted by Kent Petersen on February 14, 2012 at 20:41:37:
Quoting Removed, click Modern View to see
I can't begin to tell anyone how many trucks,cars and tractors I've either pull started,push started or hand cranked to get started with no mishaps. It dosen't take much more than one good vehicle and two people with 2 bits worth of common sence.[/quote]
That doesn't mean you have more common sense, I've done it too without any mishaps.....just means we were lucky!
Look at military refueling operations from fuel trucks. They are required to ground the fuel truck before operations. 2 times in just a few months 2 fuel trucks blew up because of faulty grounds. In both cases the trucks were grounded to steel post set in concrete, one a lamp pole and the other a fence post. One was at Sullivan Barracks, Mannheim Germany, 5/77 Armor Bn, the other at Boatwright Maintenance facility, Ft Know Ky. They had been grounding those trucks like that for many years. Same things happen while doing other things like tow starting something. All it takes is one little mistake or maybe a brake failure and it bite you in the butt.
Seems to me one type of person that get themselves in trouble around equipment are the ones who think they know it all.
Rick[/quote]
Well oldtanker I'm 70 years old and doing it my way hasen't got me yet. I think I'll keep doing it the same way. As an aside I spent 34 years in aircraft maintaince. I've refueld and defueled many many aircraft and know the importance of proper grounding. Never had any mishaps doing that either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
