Posted by Nebraska Kirk on February 14, 2012 at 19:36:34 from (207.91.4.159):
In Reply to: Looking for this pulley. posted by Nathaniel Watts on February 14, 2012 at 18:15:06:
Like Fritz said, a pulley could be made without a lot of trouble. A piece of tubing the right diameter, weld in a center and spokes and have it trued up on a lathe. If you want original style, then you would have to find someone with an original that you can use as a pattern to have a new pulley cast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
