Posted by Wardner on February 07, 2012 at 11:12:59 from (4.154.234.58):
In Reply to: 560 IH help posted by Mone on February 07, 2012 at 07:55:05:
There are two cylinders listed for W560 and 660. Each cylinder is listed for use with both models. It must be a situation where there is an early and late but there is no cut-off number for the changeover. This would seem to indicate that either cylinder can be used on any W560 or 660.
It is odd that this question comes up now. Yesterday, I received an eBay 660 cylinder and linkage. It appears identical to my existing 660 hardware except that the piston rod has a smaller diameter. The port configurations and front and rear mounts are the same.
The smaller rod was probably used to achieve more equalization in the displacement for left and right turns.
It is also interesting to compare 650 and 660 PS systems. With considerable rework, the later system could be made to work on the 650 and all 9 series. I have both models with PS so it would be easy for me as I have the pattern.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
