On the surface of your question I think you will be pushing it with that setup. We have a JD 3020 with a 48 JD loader and we needed to coax it to lift bales that weighed in that category off of the cutting edge.
I think the geometry is simple though (I could be wrong and often am) Just need to break it down. Forget the angles in the loader frame as they are just to get around wide front's. You have a couple of levers. Lever one is from the upper/rear pivot on the loader frame to the lower/rear point where the cylinder is attached. The other lever is from where the rear of loader pivots to the center of the load. Multiply cylinder force by the first lever and then divide that by the second and you should be pretty close to your lift force.
One thing you can do is shorten the second lever. One way is as you described by using forks so you moved the lift point from the edge of the bucket to where the bucket it pins in. Nother thought is to use some old hay forks like they used to use for putting up loose hay. Chain this to the back of the bucket, this may shorten it enough to move.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
