Posted by John Cooney on December 31, 2011 at 14:49:26 from (216.80.141.118):
In Reply to: Diesel tank plumbing ? posted by G.Fields on December 31, 2011 at 13:54:26:
Just a thought. By going up over and back down as you described there will be an air trap in the highest part of the piping.IF your pump is somewhat inefficient you may have a problem getting a prime. If so it may be necessary to put a verry SLIGHT!!!,air pressure on the tank to raise the fuel up to the 20 foot run of pipe. Two and a half to three pounds of pressure will be sufficient. Bear in mind every square inch of your tank will have whatever pressure you apply.Thus 2.5 lb X 144 Sq. in. == 288 pounds load on each sq. ft. of tank surface. Use extreme caution.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
