Posted by LOU from Wi. on December 23, 2011 at 21:48:54 from (174.124.35.12):
Some time back I asked Jde if he ever undertook making a holster for his hand gun./Victor made his and mine. Shoulder holster for the Long slide 45 and a clip on for the P.P.K 380.Both worked out as a beautiful projects and great fitting holsters.With buying a finished product the cost would have been $250.00 higher, learned another trade to add to the other list of accomplishments.MADE IN THE U.S.A. Bought both sets of loading dies for the new ones, so now we can load em up and shoot em out. Hand loaded for the 44 Mag- 480 with great success. Built a brick incloser for the reloader to be operated in.Supplies fit in the cabinet we built 8 years ago, so now the new supplies are here and in the cabinet to be re-loading for the 45- 380 after the holidays.Lots of enjoyment and a way lot cheaper then buying factory loads and holsters.Life isn't wasted when one LEARNS SOMETHING NEW EVERY DAY> LOU.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
