Posted by LJD on December 16, 2011 at 10:50:02 from (75.250.238.113):
In Reply to: Yo 2710 posted by John T on December 16, 2011 at 10:29:37:
Come on! My use of the word "any" is assuming some reasonable latitude and common sense here.
The power needed is figured with pull-power AND pull-in speed in mind. A 300 watt 1/4" drill could pull 5000 lbs. if geared down low enough. But it would be so slow you'd hardly see the cable move. In theory, you COULD use almost any size motor IF geared low enough, be it 200 to 1 or 20,000 to 1.
Now if my pet flea has a model airplane with a motor considered small by flea standards - yeah . . . perhaps it would not even have the power to overcome friction on moving parts - pulling NO weight.
So yeah, maybye your wrist-watch lacks motor enough to run a 5000 lb. winch, but I assume most know that's not what I meant.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
