Posted by oldtanker on December 11, 2011 at 21:58:23 from (66.228.255.223):
In Reply to: electrical conversion posted by smhimrod on December 10, 2011 at 08:14:04:
Quoting Removed, click Modern View to see
LJD....It takes a little longer to start than 15 seconds when it's -20 out. Plus I've never had an alternator hit peak out put from charging. I have an AMP meter on the tractor with the one wire. For it to get close to 0 AMPS it's gotta run about 10 min hitting a peak output of about 25 Amps. And at -20 I start and leave it about 1000 RPMS for about 10 min. Then never run it faster than that while feeding a bale which only takes about 3 min. Then it takes about another 10 min at 1500 RPMs to get the alternator to kick in and for it to drop rom about 20-25 AMPS to near 0. When you get -20 to -30 you don't play around with battery charge. You make sure before it gets cold that everything is good and then be sure to keep the battery up on charge.
Besides that the alternator may put out 50 AMPS but just because you are trying to cram that in isn't a sure bet that the battery will accept a charge rate that fast. And that advertized charge rate isn't at 1500 RPMs....
I am going over to the 3 wire on the tractor with the one wire because it will reduce the amount of time I'm out in - weather. My 2 tractors with the 3 wire charge at about 500 RPMS as soon as the tractors start. Just too bad that they are big enough to move 1800 pound bales.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
