Posted by sixtyninegmc on November 28, 2011 at 17:09:38 from (209.112.184.162):
Posted this on the JD forum as well, thought I would try here as well.
Starting to get familiar with this thing, but still have some questions. I have been having some problems with the machine shop that installed new cam bearings. I was an idiot and did not take any pictures of the old bearings, and do not remember how they were installed. I only have an IT shop manual, and it does not have a good oiling schematic. My questions are in regards to the lubrication to the head. The machinist installed the bearing with the only oil hole lined up with the hole to the head, which as far as I can tell completely blocks off the supply of oil from the pressure galley. How is the hole in the cam bearing supposed to be installed? I am thinking that it should be lined up with the slot from the pressure galley, and then the supply to the top end would be from the oil that is pushed out of the end of the bearing, so that the hole to the head is not covered by the bearing or the block plug? Also, does the notch in the edge of the bearing by the oil hole have any importance? Need to be lined up with anything?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
