I doubt that anyone would argue with you about oiling the bearings upon installing them. I think the real question was if the bearing you are checking for clearance should have oil on in the spot you are using the plastigauge. As you have to remove the cap to check the platigauge you then just apply oil again when putting the cap back on, and of course turn the crank as needed for checking.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Running Beans in East Central Indiana - by The Red, John Fritz. Fall is my second favorite season behind the long days of summer. The calendar reads late September and it�s time to start running beans. This article is about my experiences helping my farm neighbor Ernie Swoveland, along with his grandsons Jeff and Craig Ring, with the soybean harvest in East Central Indiana for the 1999 season.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
