Posted by Bob Evans on October 19, 2011 at 15:01:10 from (68.117.249.64):
In Reply to: Farmall W-4 starter posted by Wayne Young on October 19, 2011 at 14:44:18:
Wayne you do have to remove the belt pulley To get the starter out.I had to pull the starter from a Super W-4 last week.I removed the glass bowl from the gas tank with valve turned off,pulled the bolts from the belt pulley system,raised the belt pulley system up and slid over to the right.The starter still had to work it around to get it out.When starter is placed back lift the belt pulley system up and line up bolts to correct holes and place back into position and tighten bolts.I did use some gasket material by squirting some on a long screw driver spredding it over the old gasket. Hope this helps you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
