Posted by JDseller on September 24, 2011 at 17:17:22 from (208.126.196.144):
In Reply to: Barn repair posted by showcrop on September 24, 2011 at 09:57:38:
I drill through the post with a 3/4 wood bit. I then put a plate made out of a piece of channel iron on the out side to spread the load. I usually have extra gate hinge bolts that are 3/4. I weld an washer on the top of the gate pin. You can then hook your cable under that. I then string my cables. I use ratching chain binders to pull on the cables with. The binders work much better than a turn buckle. You just run the cable through the loop that the hook goes through.
I usually take several weeks to pull them back to straight. I tighten the binders up and let the barn set. You will get some winds and such that will shake the barn a little. That will loosen the binders. So you tighten them again.
Those old barns are stiff to get back to square. I have tried to pull some down that where leaning way over and they would not fall until I cut some of the bracing with the chain saw.
Just take your time and an you can get them square again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
