Posted by Fixerupper on June 26, 2011 at 10:14:49 from (207.199.205.239):
In Reply to: farm gates posted by mosinee dave on June 26, 2011 at 06:47:12:
Allan has a good idea. Your 16" highline post will tip if it's free standing without an anchor unless the post is tamped in REAL HARD with 3' of gravel or crushed limestone all the way around. 20' is a lot of gate no matter how light you try to make it. The latch with the handle sticking out of the top of the gate is the best like others said. Be careful not to make the latch too heavy cause it's way out there on the end of the gate where weight is your worst enemy. Doesn't hurt to make the latch a little loose and sloppy so it doesn't rust tight. I made that mistake years ago. I started making my gate latches to precision tolerances so everything would be nice and tight. After a year in the weather they were tight alright!!!Good luck and show us pics when you're done.
Two ten footers solves the weight problem and one ten foot gate is easier to swing from the saddle, and it will swing away quicker because of a shorter turning radius, but then you'll need a center stake going into the ground to hold one of them. Works fine in the hot dry desert country but not so well in a state that has ice in the winter. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
