Posted by John A. on June 01, 2011 at 20:57:07 from (76.1.122.180):
In Reply to: Irrigation pics posted by DeltaRed on June 01, 2011 at 18:24:39:
Delta Red, I was just Smiling great big with the gated pipe pics , then even bigger when I saw your T&F Center Pivot, thinking how much less labor is involved when we changed over from pipe to Pivots. BUT I Dannm Near went to hyper-ventilating when I saw them dang tubes, Good grief,,, 6 hr sets, broken ditches, caused by Crappy running engines, usually an old Chrysler 413 industrial on natural gas. or a hard cranking 605 International, when hot it would take 2 pickups to crank one. I saw you #1 irrigation shovel, Mine didn't have holes in it. What I didn't see, the most important tool an Irrigator needs.... His LaCross high top, fit like a glove, rubber boots! Enjoyed the pics D.R. Have a great day! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
