Posted by sourgum on May 31, 2011 at 15:23:45 from (166.137.142.219):
In Reply to: New Lawn Tractor??? posted by Hal/ Eastern WA on May 30, 2011 at 21:15:51:
I would get these things in a lawn tractor: greaseable frt wheel bearings and spindles, hydrostatic trans, either B & S or Kohler engine, a V-2 if available. The V -2 is smoother ww more power. I like a two blade deck where it meets your deck width requirement. Be sure you get an air vented deck as they will mow wet grass and never plug up. Doing an acre each week and being cheap skate ,can't see spending $6 or $9 K for a ZTR, when a medium size rider does one acre in 90 minutes for 1/4 cost outlay. Have one almost identical to what dixon describes in his post and very satisfied w/ it's performance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
