Posted by Lincoln TIG on April 27, 2011 at 07:56:23 from (68.149.56.30):
In Reply to: welder value posted by 1349 on April 27, 2011 at 03:31:03:
Make sure the cylinders aren't leased/stolen or you'll never get them filled and the owner will take them back. You need to make sure the high freq. works properly. I think the TIG 250 is basically an Idealarc 250 with the high freq. built in. There is no finer single phase stick machine than an Idealarc 250. If everything works, it should be in the $750 to $1200 range tops. The water cooler and water cooled TIG torch is worth 2 or $300 by itself. If you're not doing heavy work, you could price out a new square wave TIG 175 for comparison. If you have to bid on this one, start low around $350. You can always go up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.