|
Tool Talk Discussion Board |
Re: Re: Re: Re: Re: broken spark plug removal HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Helpful on February 12, 2001 at 12:15:32 from (140.171.37.229):
In Reply to: Re: Re: Re: Re: broken spark plug removal HELP! posted by Greg C. on February 12, 2001 at 09:00:21:
I would take about 70 grams of plastic explosive and carefully mold it around the plug. Then I would make sure that I was at piece with my God and get far away. Then use the igniter and KABOOM! Then either the plug is out or you don't have an engine head to worry about.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tire Fluids - by Curtis von Fange. It came as a surprise. The tire on the tractor needed to be pulled off to get to the brakes for service. The tires were blocked, the rear end raised on jacks, the lugs loosened and the tire loosened from the hub. Then, as the big lugged circle of rubber slipped off the last wheel stud it became apparent that there was more there than just an empty tire. Four hundred pounds of rim, tire, and fluid dropped to the ground like a sack of wet cement. Fortunately the installer jumped out of the wa
... [Read Article]
Latest Ad:
Wanted nice 1953 AC WD with nf and sc. Would prefer original. Calls only.
[More Ads]
Copyright © 1997-2023 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
