Tool Talk Discussion Board|
Re: Re: Re: Re: broken spark plug removal HELP!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greg C. on February 12, 2001 at 09:00:21 from (22.214.171.124):
In Reply to: Re: Re: Re: broken spark plug removal HELP! posted by the tractor vet on February 11, 2001 at 18:01:21:
The ez-out method works great. I used one to take a broken plug out of a 302 ford. I heated it up and used penetrating oil and it came right out. Good luck!
Today's Featured Article -
Tire Fluids - by Curtis von Fange. It came as a surprise. The tire on the tractor needed to be pulled off to get to the brakes for service. The tires were blocked, the rear end raised on jacks, the lugs loosened and the tire loosened from the hub. Then, as the big lugged circle of rubber slipped off the last wheel stud it became apparent that there was more there than just an empty tire. Four hundred pounds of rim, tire, and fluid dropped to the ground like a sack of wet cement. Fortunately the installer jumped out of the wa
... [Read Article]
Wanted nice 1953 AC WD with nf and sc. Would prefer original. Calls only.
| Copyright © 1997-2023 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy