|
Ford 9N, 2N and 8N Discussion Board |
Front axle bushing, pin, spacer and shims
[ View Follow Ups ] [ Post Followup ] [ Return to Ford 9N, 2N and 8N Discussion Board ]
Posted by Tom (Middletown MD) on November 15, 1999 at 08:04:10 from (204.255.139.148):
I'm in the process of replacing the front axle bushing and pin on my '48 8N. Found there's also a wide spacer and 3 thin spacers (shims) that fit over the pin that aren't shown on my I&T shop manual. One of these is also showing a lot of wear, so I wanted to replace it, but my New Holland dealer says they probably weren't factory installed...not in their parts book either. But they appear to be all original. ..nothing make-shift about them. Is this because I have an early-edition 8N, or is this a modification from a previous owner that just looks good? thanks for any info, Tom
Follow Ups:
Post a Followup
|