|
John Deere Tractors Discussion Board |
Re: John deere 70
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Aylward on April 27, 2002 at 20:01:02 from (207.177.31.131):
In Reply to: John deere 70 posted by POP on April 27, 2002 at 17:25:27:
Pop, this is a pretty simple and straightforward process. You will want to start at the carburetor and work backwards. With the tractor engine shut off, open the throttle wide open. Take out the governor to carburetor rod at the governor end. According to factory recommendations when properly adjusted the rod should be one-half hole short of reaching the hole. However, I set all of my tractors about a full hole short which makes them much more snappy. Once this rod is adjusted it need never be touched again. After you have done this, start the tractor and by setting either the throttle stop screw or the throttle lever to governor spring rod, adjust the fast idle speed of the engine, which is 1115 RPM. Once the fast idle speed is set adjust the idle screw on the carburetor to maintain the slow idle speed you want. This is a somewhat different procedure than what is listed in the operator's manual but you will be much more pleased with the performance of this setup. If you need more information feel free to email me. Hope this helps. Mike
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|