|
John Deere Tractors Discussion Board |
Re: 720 pops out of 4th gear only
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Clooney on January 04, 2005 at 18:36:31 from (172.130.218.2):
In Reply to: 720 pops out of 4th gear only posted by Lyle MN on January 04, 2005 at 17:00:40:
Lyle, that depends on what is popping out when it jumps out of gear? Does the shift lever move out of the gate slot or does the lever stay put when the trans just quits pulling? That will tell us if your problem is the under/over drive or actually 4th gear jumping out of gear.. -Without knowing the above information the below is just a general 720 trans problem check out.. -Probably the place to start is by pulling the trans top cover & checking the trans interlocks for operation & locking correctly.. Then check the trans top & bottom shafts for loose bearings by using a long screw driver or bar & trying to move the shafts in all directions.. Loose shafts means loose or worn bearings. -Then to go farther in & look for loose gears on the splined shaft & look closely for twisted splines on the splined shaft.. -Then pull the trans apart & look for worn bearings in the counter shaft idler gear {common on the 720 with lots of use}.. What I usually find is worn trans bearings or worn input shaft bearing & sometimes worn gears on the sliding splined shaft.. I usually also find worn bearings in the counter shaft idler gear if the trans is a high hour trans or has been run with water in trans.. Those 720 transmissions are a pain to work on & some bearings are getting hard to come by (like the counter shaft idler gear roller bearings).. If a bearing says �New Process� on it expect a problem finding it. There are many causes of that trans popping out or 4th & about all you can do is pull the cover & start looking.. Clooney
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|