|
Farmall & IHC Tractors Discussion Board |
Re: Adjusting front axle width on A - Pretty tough job
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Calvin on January 19, 2001 at 13:46:52 from (209.190.166.82):
In Reply to: Adjusting front axle width on A - Pretty tough job posted by David A on January 19, 2001 at 05:12:33:
Hi Dave I dont have a A but do own a cub with similiar front axel. I sat on a chair jacked up that part of the axel and kept banging it with a hammer and putting penatrating oil all in the cracks. Dont beat it to where you'll be denting it, also use your foot while setting down to kick the wheel as to get it to move forward or backward. Takes a while but it works, good luck,
Calvin.....WV...
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
