Posted by littlefarmer on November 09, 2014 at 19:04:45 from (74.46.112.91):
Got an advanced-level question on replacing a hydraulic 3pt hitch component on my 656.
I need to replace the lower right crank arm on my 656 3pt hitch. Item #4 in the attached diagram. Can anyone advise the particulars on doing this? I have the IH repair manual, and it has directions for removing the torsion bar draft sensing assembly, which requires removal of the wheels and IPTO. However I only need to replace the crank arm. Will it just pull out? Thanks for any advice.
This post was edited by littlefarmer at 19:07:16 11/09/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Your Tractor - by Staff. Maybe you bought it from a friend who didn't know what kind of tractor it was, or perhaps (and this is every tractor fanatics dream) you stumbled across it in an abandoned field covered with weeds but intact. In any case, you have no idea what the make and/or model is. For awhile perhaps it doesn't really matter. Especially if it runs! But pretty soon you'll probably need to tinker with it a bit and maybe buy a part or too. Having a manual is nice. But how does one go about dete
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
