Posted by littlered1 on August 01, 2014 at 07:29:44 from (173.233.188.93):
In Reply to: Super C Oil Change posted by JBlavl on August 01, 2014 at 06:41:19:
I have no idea how much oil a Super C crankcase holds. I am assuming that you put in the correct amount. Do you per chance know how much oil you drained out?
Did the Super C have oil pan pet cocks? Is the dipstick a replacement for same? Could the dipstick be wrong?
When changing oil I always add enough to show above add on the dipstick or petcock. Then I crank and run for a minute or two and check the oil again. I add as necessary and check again. Run again, and make another check. When it shows full I crank and run for a few minutes and make sure nothing is leaking and then check again.
Crank your SC and let it run for a few minutes and check the oil again. I don't think a half quart over will harm anything.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
