|
Farmall & IHC Tractors Discussion Board |
Re: Re: 806 hydraulics, steering, brakes and TA prob.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on December 30, 2000 at 14:35:13 from (199.174.184.19):
In Reply to: Re: 806 hydraulics, steering, brakes and TA prob. posted by Lee K. on December 30, 2000 at 13:52:56:
Yes, from what I've been reading in the manuals it looks to be a problem with the MCV system. As stated in another follow up I quite a newbie to this tractor stuff. How much work is involved with getting the MCV parts apart. I don't have a building big enought to get the tractor inside, so I'm working outside in the snow and we have lots of it this year (15 mi. east of St. Paul, MN) The main hyds. and PTO are working properly. I don't see a red light on or blinking. Would this indicate a blockage rather than a bad pump? Wayne
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
