|
Farmall & IHC Tractors Discussion Board |
Tractor Pulling
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert Almstrom on December 29, 2000 at 11:56:13 from (209.90.238.107):
Hi: I have a friend that is going to assemble a Funk V8 engine into a Ford 8N. The weight for this tractor goes about 2500lbs. and now with the Funk V8 I don't know where the weight will be. I have a Farmall Super C and want to enter the pulls this coming April, but how am I to avoid pulling against this monstor? Does he have a chance or will he spin out? I do believe that he will be in the same weight class with that engine around 3000-3200lbs. I like to keep the Farmalls on the board and any help will be greatly appreciated. We do also have to keep our tractors standard, but we can tinker and do all the tuning we want. Is he running a standard engine? Did Ford place this engine in at an optional request? Thanks! any help is appreciated! Bob
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
