Farmall & IHC Tractors Discussion Board |
Re: Re: Re: WHY?!?!?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by twopop on December 03, 2000 at 09:59:55 from (208.209.103.36):
In Reply to: Re: Re: WHY?!?!? posted by Dick B on December 03, 2000 at 07:27:01:
running an engine w/o the thermostat in is a big mistake.some people who have cooling problems,take it out and then because the guage reads low,figure everything is ok.the problem here is then the water moves thru the engine very quickly and does not have enough time to transfer the heat from the metal into the water,causing the metal to be hotter than it should be,therefore causing excessive wear,and the wear increases toward the rear of the engine.ie #6 cylinder will wear more than # 1
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|